Nikon capture nx d latest version4/12/2023 ![]() And if you are a control freak like me set it back to Recorded Settings before you close NX-D. ![]() After you are finished adjusting each file simply click and reset to Recorded Settings to ensure no settings affect you next file. To ensure it does you can go to Adjustments and click on Recorded Settings. Each time you open NX-D it should be in default mode. When the window opens you will see your version number. The whole reason I switched to NX-D was for the benefit of having the default conversion automatically reflect the Picture Control settings set up in the camera (which I have twiddled to my preference) and to leave any adjustments to that default condition to be individually managed for each image based on the requirements of that particular image. ![]() My workflow is already inefficient enough by converting with NX-D and then saving and moving a 16-bit tiff to non-Nikon software for further processing in an environment whose user interface and features I prefer to Nikon's approach. I guess if my version did that, my workflow would have to involve closing and then re-opening NX-D again and again after every image that I converted. Second, are you saying that if you make an adjustment to one raw file (such as adjusting exposure by one half stop or tweaking the white balance temperature), that when you move on to convert the raw file for the next keeper image, the software automatically applies that exposure or white balance adjustment as the default conversion setting? That would be horrible for me because only a single image in a series of shots may need an exposure or white balance adjustment. So I must be working with yet something different altogether, eh?. This does not match the numbers for either the old or the new versions you fellows have quoted above. I am a fairly new NX-D user and am confused about what you are talking about so I would appreciate some clarification.įirst, I checked at the location where my version is stored and it says it is "File Version 1.". ![]() Make sure you have "Use source folder" checked in the 'Convert selected file' menu. From past experience it can be tricky to set up directory and naming criteria. But that suites 'me! It vanished in recent updates but is now back. I haven't had the time to test the new version extensively but so far it's been quite stable for me (Win 8.1, 64-bit). Has anyone else encountered the same issues?Īctually the 1.4.3 version was unstable for me, crashing in unpredictable moments, with memory leaks and constant usage of processor when idle. I don't save my exports into the original folder but to a temporary RAM-disk drive, though.īug 2: In Picture Control, when a setting is changed, say to vivid, the adjustment bars, such as sharpening, clarity etc, become gray, so it is not possible to adjust these parameters. However, I don't see the new, empty directory behaviour you're describing. I can confirm the batch mode behaviour, even if I choose to export one image - it didn't use to do that in the previous version. When you go back to the original directory, your changes are lost. However, the parameters are never saved in either the new or the original directories, causing the loss of the changed parameters permanently. Apparently, it moves into that new directory as working directory (so you cannot see any photos), and tries to save changed parameters in that directory. I had to go back to ver 1.4.3.īug 1: After converting a modified photo to JPEG (the new version always uses the batch mode to do conversion), the software creates a new (empty) directory with the same name as the current directory, but at the root of a drive. I have installed the latest version of Capture NX-D (ver 1.4.5) and found two bugs that make the version unusable.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |